You can access your voicemail by modifying the AA dial plan.
For example, if you AA dial plan contained <:7:vmm3>, that means upon entering 7 during the listening of the AA, you would be connected to the line number 3 of the spa9000 which is configured to the spa400 (hence the vmm3), then you would hear it ask for ext number and pin number to access the voicemail.
It can be any of the four lines of the spa9000 connected to the spa400 voicemail, so the vmm could be vmm1, vmm2, vmm3 or vmm4.
Thus, after no answer, an inbound call on either line rolls straight into the voicemail greeting for the extension in question. It is when I am listening to the voicemail box greeting that I want to be able to login, but it appears that once I get to the voicemail greeting, I cannot get back to the auto attendant or in any other way login to access my voicemail.
If I replace the cfwd value on the second line with "aa", then I do get the auto attendant and your trick works, but then the employee on extension 102 no longer gets voicemail on no answer.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...