I have had one of our SPA400's die. Bought a new unit and I am having issues with getting it to hold a static IP assignment. I have updated to the latest firmware 22.214.171.124 and the unit wont hold a static IP assignment, It always defaults back to 192.168.1.2, this is also the case even with it obtaining an IP address from a DHCP server. It will always default back to 192.168.1.2.
It doesn't save the static address that you enter? Set to DHCP and it doesn't get an IP address from the DHCP server? If it's stuck at the same IP address regardless of the changes that you make, please try resetting the device. Push the reset button and hold for about 10-15 seconds until the green lights flash indicating unit has been reset.
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
This document is a must-read for all SPA232D installers, administrators,
and users. The document takes you from unboxing the SPA232D ATA and
SPA302D DECT handsets, through DECT handset registration, and connecting
to the PSTN and ITSP.The document describ...
Save yourself hours or even days of searching for ATA resources by using
this document!Turn View Bookmarks on when viewing the document for best
navigation. [View > Navigation Panels > Bookmarks]Use the links in this
document to easily locate resources re...