I am having issues with a cisco SPA8000 and Avaya Office IP 500. I am using the SPA to provide dial tone to the switch. Everything is working except releasing (Dropping) a conference call. The lines participating in the conference call are getting stuck and will not release the ports on the SPA. If I iniate a single call, 1 line active and use the DROP key or release the call everyhting is fine. This only occurs during a conference call. Any help would be extremely appreciated.
Network Address Translation (NAT) Settings for Lines on PAP2T and SPA3102 Phone Adapters
The objective of this document is to configure Network Address Translation (NAT) settings for the lines of communication on the PAP2T ...
Speed Dial Settings on SPA100 Series
Speed Dial Buttons are often used to make the process of calling regularly used contacts quicker and with one button. This option is used in place of dialing the entire phone number in. ...
Firmware Upgrade on SPA112 and SPA122
To upgrade the firmware a specific file must be downloaded from the Internet and uploaded to the device. Upgrading your devices can be very useful. Firmware upgrades can fix software bu...