Does anyone have suggestions for configuring a line on this 8 port ATA for faxing? I have quite a few that can either send or receive and some that won't do anything. I use 4 ports for phones and 1 port for faxing (Ricoh)......any suggestions/advice would be greatly appreciated.
You asked in wrong community, so you didn't received answer yet.
According your question itself - use uncompressed codec (G.711), 10ms packet time. Limit fax speed up to 9600Bd (both Tx and Rx). But most important parameter is reliable connection between SPA8000 and the PBX.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...