I am looking for a doc regarding the default parameters of an spa8k ata on release 6.1.3. I have not really seen anything in the ata provisioning guide and in the release notes, I only see how to assign a line to a trunk group. I would like to know the default values of the trunk group settings and the syntax needed to adjust any of those values.
I tried to use the spc tool on win32, but the utility does not run for me...just closes, so I can not get a default config file.
You are on the right direction. SPC is a DOS tools, so open the DOS command line and type the executable name once you are on the right directory... once you type the executable name you will get all options for getting a template.
Network Address Translation (NAT) Settings for Lines on PAP2T and SPA3102 Phone Adapters
The objective of this document is to configure Network Address Translation (NAT) settings for the lines of communication on the PAP2T ...
Speed Dial Settings on SPA100 Series
Speed Dial Buttons are often used to make the process of calling regularly used contacts quicker and with one button. This option is used in place of dialing the entire phone number in. ...
Firmware Upgrade on SPA112 and SPA122
To upgrade the firmware a specific file must be downloaded from the Internet and uploaded to the device. Upgrading your devices can be very useful. Firmware upgrades can fix software bu...