I've been setting up a system using 6xSPA942, 5xSPA8000 and 1xSPA8800. There is no actual VOIP outgoing or incoming. This is essentially a stand-alone training system, however I do need for people to be ableto dial out using the FXO lines on the SPA8800 (UK lines). I have everything else working just fine, but I've hit an impass with the FXO lines. I've followed the guide as best I can, but it seems as if there is a problem between the Asterisk server and the SPA8800 (although the 4 FXS lines work just fine).
Dial In:- I ring in and from the SPA8800 configuration utility I can see that the line is ringing. However it seems to answer the line after the apropriate wait time and then dump it.
Dial Out:- I ring out from an extension and the Asterisk server tells me it tries, but then gives:
SIP/Line1-00000033 is circuit busy
Everyone is busy/congested at this time (1:0/1/0)
Salient parts of the .conf files are as follows (numbers changed to protect the innocent):
This problem remains unsolved. The system is now installed at the customer's site, but it's only a matter of time before they ask me for outgoing calls (it's a training system, so it's mostly internal calls only)
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...