Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SPA8800 CLID doesn't work

In my country (the Netherlands) CLID doesn't work on SPA3102. A firmware update is promised on this forum, fixing those issues.

Same applies to SPA8800. No CLID of KPN Telecom PSTN lines. I was hoping that the issues with SP3102 would result in a firmware update for SPA8800 as well, but haven't seen any anouncement indicating that.

Am i the only one with this problem on a SPA8800? Will there be a firmware update fixing this?

Peter

1 REPLY
New Member

Re: SPA8800 CLID doesn't work

Yes, this will apply to the 8800 as well.  The 8800 release roadmap is later than the 3102.  Probably about 4-6 months....

480
Views
0
Helpful
1
Replies
CreatePlease to create content