Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

mh
New Member

SPA8800 Firmware - Bridge/Switch mode

My SPA8800 has firmware 6.1.7 (GW). The Quick Start Guide lists an IVR Action # 201 for setting the device mode for Router/NAT or Bridge/Switch. The IVR however reports this option to be invalid. Web interface does not have the option either. I would like to use the Bridge/Switch mode. Will this require a firmware update or have I missed something configuration wise ? Where do I find the required firmware update ?

Everyone's tags (4)
2 REPLIES
Cisco Employee

Re: SPA8800 Firmware - Bridge/Switch mode

Dear Sir;

SPA8800 is a client device. The LAN port cannot be used other than for Admin purposes, and it is set in NAT mode (should not be changed). I will ask the documentation team to have a look and potentially correct the document to remove this option from the documentation.

Thanks for highlighting this issue and helping us to make better products.


Regards
Alberto

Cisco Employee

Re: SPA8800 Firmware - Bridge/Switch mode

Hi mh@mhc.dk,

Thanks for letting us know about the documentation error.

We've revised the SPA8800 Quick Start Guide. The updated version is available here:

http://www.cisco.com/en/US/docs/voice_ip_comm/csbpvga/SPA8800/quick_start/guide/REV_SPA8800_QuickStart.pdf

I have also linked to it from the Community's ATA documentation page: https://www.myciscocommunity.com/docs/DOC-2149

Regards,

Patrick

-----------

3514
Views
0
Helpful
2
Replies