I would like to use the SPA8800 to link up the telephone system of my offices at 2 different locations. Is it possible to connect the SPA8800 to the in-house telephone system which also use 4 wires RJ-11 plugs? i.e. SPA8800 connect to my system box, PAP2T connect to the phone, and link up SPA8800 and PAP2T by internet.
I had ordered 2 SPA8800 and looking forward to connect the old Panasonic key phone system with the exchange box in one location. Is there any special settings that I need to "tell" the "SPA8800" other than just plug the phones and set the internet connectivity?
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
This document is a must-read for all SPA232D installers, administrators,
and users. The document takes you from unboxing the SPA232D ATA and
SPA302D DECT handsets, through DECT handset registration, and connecting
to the PSTN and ITSP.The document describ...