Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UC560, PAP2T & DECT phone Recall button (hookflash)

We have a scenario with a PAP2T ATA registering as a SIP device to a UC560.  Plugged into the PAP2T are some Kirk 4040 DECT handsets.  Calls to and from the handsets work fine, but the 'R' (Recall) button used to place a call on hold does not work.  The other end of the call can here a tone when the button is pressed but nothing happens.  The voice register pool on the UC560 is set to dtmf-relay rtp-nte (i.e. RFC2833), inline with this document on the SPA8000 - https://supportforums.cisco.com/docs/DOC-9596.

Can anyone suggest any settings on the PAP2T to get this working please?

Many thanks.

1 REPLY
Green

UC560, PAP2T & DECT phone Recall button (hookflash)

Hi,

I think the issue here is that when the user of the DECT phone presses the recall button a DTMF tone is being sent.

What I think you need is for the recall button to send a loop time break instead

On some POTS phones you can see a switch on the phone which allows you to select the RECALL type to be either TB or TONE.

You could try a quich press and relaes of the switch hook , I think this is masked on your DECT with a handset symbol.

To prove the point you cold also try using a POTS phone with TB recall on the port that the dect is using.

I did try a google for the kirk 4040 manual but there was no mention of changing the signalling used for RECALL.

Hope this helps

Regards
Alex

Regards, Alex. Please rate useful posts.
461
Views
0
Helpful
1
Replies