Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Wall mounting a SPA3102

Why are there no wall mounting slots on the bottom of the SPA3102?

  • ATAs Gateways and Accessories
Everyone's tags (1)
3 REPLIES
New Member

Re: Wall mounting a SPA3102

My 3102 has two punch outs (look like a T), see if yours has that and you can punch those out so that you can put two small screws in a wall and hang the unit via the punch outs.

New Member

Wall mounting a SPA3102

I've tried punching them out.. just distorted the back.. then I tried carefully drilling through the back (thereby destroying one unit)..

Why didn't CISCO punch them out (while putting some barrier between the intended screws and the PCB)? I need to hang these! The only way I see now is removing the rubber (sticking) covers to the screws holding the unit together.. removing the entire back.. the trying to drill holes - this is not a typical solution - is there some point on these punchouts that will yield?

New Member

Re: Wall mounting a SPA3102

it should have this. in order to distribute heat.

1283
Views
0
Helpful
3
Replies
This widget could not be displayed.