Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Which SPA3102 Params to tweak?

Hello,

we have a 3102 set up as an ATA device only for an Analog Phone (the PSTN port is not used). The 3102 is connected to a software IP PBX. Onbound/outbound calls are working fine, we just have an issue with the caller ID displaying on one particular analog phone.

Here's the scenario and what we did so far to troubleshoot:

+ Aastra Venture NT2N81AA115: placing receiving calls ok; no CID displayed when attached to 3102; CID displayed fine when attached directly to PSTN line;

-> additional info: phone ringing seems "truncated" at times; phone flashes message waiting light correctly when voicemail is received

+ other analog Phone: CID displays when attached to 3102

This leads me to the assumption that likely some communication paramters need to be tweaked on the 3102 so that the Aastra Venture correctly "understands" the 3102.

Can someone point me in the right direction which parameters to adjust?

Thx in advance!

Rgds - Marcus.

Everyone's tags (1)
2 REPLIES
New Member

Re: Which SPA3102 Params to tweak?

Hi Marcus,

This has become a known issue and has been reported.  Check out the following thread to follow it's progress.

https://www.myciscocommunity.com/message/19358#19358

Thanks

New Member

Re: Which SPA3102 Params to tweak?

Hi Derek,

thx for the reply. Can you verify the link you posted? It's pointing to this thread - ??

Thx - Marcus.

1550
Views
0
Helpful
2
Replies