Hi I have a WIP 310 V2 and it was working prety good for a while and then....its start with a problem with the wifi .....Its stay all the time acquiring Network.... but never find a network.
So i start to find out whats going on and I found that the Software version its missing ... so i re install the firmware version available at cisco download site ..... and in the loadder ..... appears everything good, and the notice that the phone were upgraded.
Ok .... but Im still having the same problem ... no software version and unable to find any wireless network.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...