I am only getting 10mbps through my DMVPN and I can't find any documentation that explains this. My Hub router 2911 is connected to a 100 Meg circuit and the two spokes routers (2901s) are also connected to 100 Meg business class internet service. Both routers are running IP Base with Security image and I am getting pretty good speeds for traffic that is not going over the tunnel. Do I Advance IP Services load to get more speeds? I was very excited when I read about this DMVPNs as they pretty easy to setup but now this limitation is putting brakes on our big deployment. Any suggestions????
Hi I have this primary configuration on the primary CSR Router in the HA
mode in same AZ but I am not seeing failover to secondary CSR I am
seeing on the backup router that the API call was successful. 10 10 Actv
success Thu Jun 9 18:13:50 2016 syslog app...
In today’s modern networks the interaction between applications and
network infrastructures is increasingly important for service providers,
content providers and enterprise businesses. The more network operators
can interact with the network the more opt...