Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CSCee13412 - Support for Sending RedirectNumber IE in H225 SETUP

Hi, I have the following problem. May be it is regarding this Bug. A redirected call comes from CUCM to H323 VGW and leave Pots Dialpeer BRI S0 ISDN as a Q931 Setup Message. But redirected number is not seeing in Outgoing Q931 Setup, only the Calling and Called Party Number.

It should be transmitt also the Redirected Number.

Any help are appriciate.

Thanks in ahead.

HTH, please rate all useful posts!     

Best Regards Armin

HTH, please rate all useful posts and right answers.
2 REPLIES
Cisco Employee

CSCee13412 - Support for Sending RedirectNumber IE in H225 SETUP

Hello Armin,  Please confirm the call flow. I think i hear you saying the call flow is:

IOS1->h.323->CUCM->H.323->IOS2->BRI

A few questions:

  • Is redirecting IE presented from IOS1? (debug h225 asn1)
  • Is CUCM configured to receive redirecting number inbound on h323 gateway config for IOS1? (ccmadmin, check CUCM SDI/SDL traces)
  • Is CUCM configured to send redirecting number outbound on h323 gateway config for IOS2? (ccmadmin, check CUCM SDI/SDL traces)
  • Does IOS2 receive redirecting number from CUCM (debug h225 asn1)

This problem breaks down into if CUCM is sending it and then if IOS is passing it from h.323 to ISDN BRI leg.  Debugs will help to confirm where redirecting number is being dropped.

You may consider opening a Cisco TAC case for additional assistance. I recommend starting with Communications Manager.

Regards,

Wes

Community Member

Re: CSCee13412 - Support for Sending RedirectNumber IE in H225 S

Hi, thanks for your replay and support. The Redirect recieve the IOS VGW. I see that in the Trace at the Voice GW. I have found the problem now. After I set this Parameter

tkgwdemo(config-if)#isdn out ie redirecting-number

it works.

Here the config.

interface BRI0/1/0

description QSIG MRS

no ip address

isdn switch-type basic-net3

isdn overlap-receiving T302 3000

isdn protocol-emulate network

isdn layer1-emulate network

isdn incoming-voice voice

isdn outgoing display-ie

isdn outgoing ie redirecting-number

isdn static-tei 0

isdn skipsend-idverify

!

Nov 26 09:23:33.451: ISDN BR0/1/0 Q931: TX -> SETUP pd = 8  callref = 0x10

        Bearer Capability i = 0x9090A3

                Standard = CCITT

                Transfer Capability = 3.1kHz Audio

                Transfer Mode = Circuit

                Transfer Rate = 64 kbit/s

        Channel ID i = 0x89

                Exclusive, B1

        Calling Party Number i = 0x2181, '006157915399'

                Plan:ISDN, Type:National

        Called Party Number i = 0x80, '62991'

                Plan:Unknown, Type:Unknown

        Redirecting Number i = 0x00008F, '106'

                Plan:Unknown, Type:Unknown

HTH, please rate all useful posts!

HTH, please rate all useful posts and right answers.
298
Views
5
Helpful
2
Replies
CreatePlease to create content