Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CSCtd63041 - percentCONST_DIAG-SP-3-HM_FCI_0_STUCK on Mago

Dear Sir,

Regarding to the bug, can you post more in detail? how to disable non-intrusive diagnostics test? what is the detail error log? Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: CSCtd63041 - percentCONST_DIAG-SP-3-HM_FCI_0_STUCK on Mago

This appears to only be informational and can happen when 
running the diagnostic loopback test.
The suggested workaround is to disable this test,
which can be done with the following command. Switch#(config)#no diagnostic monitor module 1 test 4 However, there is newer released code that has the bug fixed. 
Installing the newer code (SXI4 or better) would be the more effective fix.
1 REPLY
Cisco Employee

Re: CSCtd63041 - percentCONST_DIAG-SP-3-HM_FCI_0_STUCK on Mago

This appears to only be informational and can happen when 
running the diagnostic loopback test.
The suggested workaround is to disable this test,
which can be done with the following command. Switch#(config)#no diagnostic monitor module 1 test 4 However, there is newer released code that has the bug fixed. 
Installing the newer code (SXI4 or better) would be the more effective fix.
666
Views
0
Helpful
1
Replies
CreatePlease to create content