CSCub21489 - Duplex Mismatch on PC-Port of IP Phone causes slow
Hello Tommi, This would only affect phones in the 69xx model range. The 79 model phones use a different hardware switch and different code base. To research this in Bug Search Tool I would search for "7941, 7942, 7945, 7961, 7962, 7965, 7970 and throughput slow duplex cos drop" and permutations of that. With web access enabled the phone web pages will show frame drops on each port of the phone. This may provide some additional troubleshooting information. It's also a known problematic issue of the switch-phone interface negotiates a slower speed than the phone-pc interface. Otherwise, please open a TAC case for additional assistance. Regards, Wes
Introduction to Essential Utility for Optical Network ProfessionalsSnapshot of utilityFeature SupportedComposite Power calculatorNet Composite power Change when some channels are added/removedDirect Conversion for multiple parametersUse CasesSupported Tec...
There are few interoperability issues between 2960x and other vendors. In this article we will go over the steps on how to debug these issues.
Check the phy id from “show controllers ethernet-controller phy” output.
<snip from show controllers ethe...
It appears that you are trying to access end of life information from Cisco search. We have detected a problem with your script ("eol...) and would like to help. Please contact firstname.lastname@example.org if you would like support.