I ran into this, not realizing it was a bug until after I'd already had this problem. I was not able to recover, and re-built the subscriber. After rebuilding the subscriber, dbrep was still broken. But, some jiggling on/off of replication and repair eventually caused it to come up, and it appears to be working just fine now.
The install for the 10.0.1 doesn't allow you to add a patch on install, so I had a bit of a hold up making sure I had a bootable for 10.0.2, but after that it was the usual hassle. Just a heads up for anyone that does ram into this one, you can get yourself out. Pub runs but administrative page is not accessible while you have the subscriber pingable/running since it's trying to talk to it.
There are few interoperability issues between 2960x and other vendors.
In this article we will go over the steps on how to debug these issues.
Check the phy id from “show controllers ethernet-controller phy” output.
It appears that you are trying to access end of life information from
Cisco search. We have detected a problem with your script ("eol...) and
would like to help. Please contact firstname.lastname@example.org if you would
Cisco Licensing is pleased to announce the new Licensing Portal. It
provides customers with an enhanced self-service experience by
stream-lining and automating many licensing activities. Please take a
moment to familiarize yourself with the features that ...