Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RJ45 Port on EHWIC-1GE-SFP-CU won't automatically connect after disconnection.

Hi, I am having trouble with the EHWIC-1GE-SFP-CU in a 1941 ISR router.

It works normally but after a cable disconnection, the interface needs to be bounced (shut / no shut) to get it to work. There seems to be a few bugs relating to this type of problem but no obvious fix.

Can you helps please.

FYI - System image file is "flash0:c1900-universalk9-mz.SPA.152-4.M4.bin"

interface GigabitEthernet0/0/0
bandwidth 6000
no ip address
ip flow ingress
load-interval 30
duplex full
speed 10
no cdp enable
service-policy output shape
end

thanks.

2 REPLIES
Cisco Employee

RJ45 Port on EHWIC-1GE-SFP-CU won't automatically connect after

This forum is for the discussion of specific, numbered open bugs.  if you think you have a new bug, you will get better results if you ask on the relevant technology forum or open a TAC case.

Hall of Fame Super Gold

RJ45 Port on EHWIC-1GE-SFP-CU won't automatically connect after

speed 10

Now I have never used the EHWIC before but are you certain the command to drop your SFP port to "10 Mbps" is necessary?  I mean you have a shapping policy in place already.

337
Views
0
Helpful
2
Replies