Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Questions about setting up NAT at home.

I have just purchased a cisco router to setup NAT at my house.  I'm a little consufed on how to set this up.  I understand the WAN port is going to be the Cox ip address (nat outside), but I'm not sure how to set the nat inside.  I don't have any computers near the router, so I'm not sure how to set it up without something physically connected to one of the interfaces.  Can someone help me on this?

2 REPLIES
New Member

Questions about setting up NAT at home.

Really?  Almost 80 views and no one can give any insight? Could I just create the nat inside on a vlan?

Questions about setting up NAT at home.

Hi Alen,

normaly you have to set the Lokal LAN Interface as NAT inside Interface.

ISP <- (NAT outside - Router - NAT inside -> Lokal LAN

For example: FE 0/0 (NAT outside) connect to you ISP and FE 0/1 (NAT inside) Interface to you Lokal LAN

BR

Hans-Juergen Guenter

939
Views
0
Helpful
2
Replies
CreatePlease to create content