Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multiple FLAT interfaces (dot1q) on CML?

Hi I would like to connect CML to a traffic generator simulating PEs through one physical interface on the Hypervisor using Vlan. But during the installation of CML (settings.ini) I don't see any option in order to setup multiple FLAT networks.

Any idea if it is supported?

 

Many thanks!

 

Youssef

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Hello Youssef,Yes, you are

Hello Youssef,

Yes, you are correct..

 

Thanks & Regards,

Vidyasagar.

5 REPLIES
Cisco Employee

Youssef, Thanks for the

Youssef,

 

Thanks for the question!  We'll have someone check into that and someone will post an answer as soon as we have something to share.

Thanks,

DavidM

New Member

still be nice to have

still be nice to have multiple flats without vlans. 

New Member

Hi You can specify multiple

Hi You can specify multiple interfaces and VLANs are part of the setup -

See page 21 – Step 12 – of the Install Guide (http://www.cisco.com/c/en/us/td/docs/cloud_services/cisco_modeling_labs/v100/installation/guide/administrator/b_cml_install_sys_admin.html)

 

New Member

Hi, so I can repeat Step 12

Hi, so I can repeat Step 12 and finally have more than one FLAT network, it will be taken in account in the settings.ini file of CML?

Am I correct?

 

Thanks!

 

Youssef

New Member

Hello Youssef,Yes, you are

Hello Youssef,

Yes, you are correct..

 

Thanks & Regards,

Vidyasagar.

307
Views
0
Helpful
5
Replies