I have an issue with DCNM 7.0.2 new install. When configuring event forwarding via email only events that are generated with the severity 'Warning' are forwarded on. Everything else appears to be ignored.
Has ansone come across this issues.
All mail settings are correct and test work fine, Have generated 100 warnings by shutting down all VPC ports and I get all those alerts. However if I shout down the VPC peer link I dont get the errors or criticals. Even if I set the alert forward to critical and above.
Hi Mike ! Can you help me ? I need your help I can't find the way to send an email alert . All mail setting are correct , but when i click "Apply and test" , nothing happen ? i can send a report , but email alert is not Can you send alert with these event ?
-Interface goes down
-CPU higher than threshold Please help me , my email is : firstname.lastname@example.org Thank you so much
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...