Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Configuring pri-group on slot 0 in the 2801 router generates the Insufficient resources to create pri-group error message

Core Issue

Slot 0 of the 2801 router supports voice only and cannot be used for configuring PRI, which is used for voice and data.

Resolution

The pri-group can be configured in Slot 1, Slot 2 or Slot 3. However, you cannot install and configure the VWIC-MFT-XX card in Slot 0 of the 2801 router because this slot supports voice only. It does not support the pri-group configurations.

For more information, refer to the Installing Modules and Interface Cards section of Chassis Installation Procedures for Cisco 2800 Series Routers .

Comments
Community Member

Really Helpfull

3322
Views
10
Helpful
1
Comments