Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

CTS 1.7.0 - CSCtj95519 : Projector defaults push thru ACU Auto/Manual will fail if it is power cycled

Symptom:

         Unable to push projector defaults from Admin Web page thru ACU to wake up projector
         Unable to see projector output from local or remote share.

Conditions:

Projector lost power momentarily, power is then restored returning to an off/standby state (Red LED state for Power).

Additional Details:

Group 100 settings are assumed  to be properly configured on projector and ACU is properly connected
http://www.cisco.com/en/US/docs/telepresence/cts_admin/cts_troubleshooting/cts_trbl_presentation.html

Note : The Sanyo PLV-Z700 projector does not require the Group 100 setting. The PLV-Z4,PLV-Z5 and PLV-Z60 all need the manual application of the Group 100 setting when the projector is first installed.

Workaround:

         Must manually turn on projector either with remote control or press the on/off button located on projector.

941
Views
0
Helpful
0
Comments