Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

How to configure a Cisco IOS® gateway to match outbound dial peers to POTS and VoIP call legs

Resolution

In order to match outbound dial peers, the router or gateway uses the  destination-pattern <called_number> dial peer  command.

On Plain Old Telephone Service (POTS) dial peers, the port command is then issued to forward the call.

On Voice-Network dial peers, the session target command is then issued to forward the call.

When outbound peers are matched, the user must consider Direct Inward Dial (DID) cases as well as non-DID.

For additional information, refer to the Matching Outbound Dial Peers section of Understanding Inbound and Outbound Dial Peers Matching on IOS Platforms.

Version history
Revision #:
1 of 1
Last update:
‎06-22-2009 06:11 PM
Updated by: