cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
12463
Views
15
Helpful
1
Comments
Paula Talamo
Cisco Employee
Cisco Employee

 

 

Introduction

 

This document provides information on how to disable any audio/video/data protocols on the C-Series, EX-series and E20 Endpoints.

 

Core Issue

Configure the endpoint to communicate using specific audio, video and data protocols in both SIP and H.323 calls.

Resolution:

 

Any audio/video/data protocols can be disabled on the C-series, EX-series and E20 endpoints through the use of the capset filter functionality. This is available through the GUI, web interface or API and can be used to remove any and all protocols you don't need for communications.

 

Here are some quick examples:

force G.722.1 -> disable all other:
xConfiguration Experimental CapsetFilter: "AAC-LD;G.722;G.711a;G.711mu;G.729AB;G.729;G.729A"

disable H.263
xConfiguration Experimental CapsetFilter: "H.263"

Disable H.239/BFCP:
xConfiguration Experimental CapsetFilter: "H.239Ctrl"

Disable support for RTCP-Feedback i.e. video fast updates over the RTCP channel
xConfiguration Experimental CapsetFilter: "RTCP-Feedback"

reset
xConfiguration Experimental CapsetFilter: ""

 

This command will not reset after boot, so please remember to use the reset command.

 

 

Thanks to Jordan Owens for this information.

 

 

Comments
Bob Fitzgerald
Level 4
Level 4

How would you filter H.263+

Found it in the TelePresence Endpoint Technical Handbook.  It's H.263PP

Thanks!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: