What is Access Point?
Architecture for AP in a Site:
Step 1: Using the Console Cable, connect your Laptop to console port of the Access Point.
Step 2: Run the tftp.exe file in the TFTP Folder to get the TFTP IP Address.
Step 3: Open the hyperterminal, give any name, click the icon and then press ok.
Step 4: Select the COM Port and then press ok.
Step 5: Set the Restore default, after that press ok.
Step 6: Go to Privilege mode. Type the command as follows
Step 7: Type the command show flash to view the old and new firmware name.
Step 8: Delete the old firmware file by
Step 9: Now again type the show flash command to check whether the
old firmware file is deleted.
Step 10: Reload the Access Point by giving the command
Thanks Devi for sharing this useful information.