Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

The user Cannot configure T.37 store-and-forward OnRamp on a Cisco 2611 router and callers from PSTN experience a fast busy signal with the "%LAPP_ON_MSGS-6-LAPP_ON_CAUSE_NO_MEMORY: No memory available" error message

Core Issue

The T.37 store-and-forward onramp requires the system have at least 2MB IO memory and 8MB process memory. If either of these memory requirements are not met, the T.37 fails due to insufficient memory.

Resolution

To resolve this problem, increase the IO memory to 10 percent. Issue the memory-size iomem 10 command in the global configuration mode.

For configuration assistance for T.37 OnRamp faxing, refer to T.37 OnRamp Faxing.

1241
Views
0
Helpful
0
Comments