Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Call from C-series to MXP series codec

Hi,

I have a SX20 and EDGE 95. When a call is placed from SX20 to EDGE and input is switched (so far end doesn't see any incoming video), EDGE decides to show a frozen image of the camera instead of blanking out the image. If the call is placed from EDGE to SX20 or SX20 to any C-series Codec, it works as expected and shows a black screen.

The firware version on SX20 is 6.2. Is it something inherent to C-series codec when placing call to legacy products or something in the firmware that can be correct?

Can anyone please advise?

Regards

D

490
Views
0
Helpful
0
Replies
CreatePlease to create content