Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CUMP 8.5; Should Director Fail-Over Cause Audio Conf Be Discon?

We have a two region CUMP 8.5.5.14 global deployment with WebEx Type II deployment, which we are now piloting. We have a primary Director in one region and a backup Director in another. During fail-over testing in which we establish an audio/web meeting (using the primary Director to setup the call), and we force a failover of the primary Director (by disconnecting network connection(s). After approximately 5 minutes, the audio conference is disconnected. Callers can call back in, but I’m trying to understand whether this Director failover behavior is expected, where the audio conference would be disconnected. Otherwise , failover to backup Director does appear to be operating OK.

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

CUMP 8.5; Should Director Fail-Over Cause Audio Conf Be Discon?

Hi Michael,

That is expected behavior.

http://www.cisco.com/en/US/docs/voice_ip_comm/meetingplace/8_5/english/administration/topology_management.html#wpxref82514

Configuring Meeting Director Nodes

Your first node is automatically configured as the Primary Meeting  Director node. The second node you add to your system is automatically  configured as the Secondary Meeting Director node. If your Primary  Meeting Director node fails, your Secondary Meeting Director node  becomes the active Meeting Director. Any conferences currently running  on the system are interrupted but attendants can dial back in  immediately.

-Dejan

2 REPLIES
Cisco Employee

CUMP 8.5; Should Director Fail-Over Cause Audio Conf Be Discon?

Hi Michael,

That is expected behavior.

http://www.cisco.com/en/US/docs/voice_ip_comm/meetingplace/8_5/english/administration/topology_management.html#wpxref82514

Configuring Meeting Director Nodes

Your first node is automatically configured as the Primary Meeting  Director node. The second node you add to your system is automatically  configured as the Secondary Meeting Director node. If your Primary  Meeting Director node fails, your Secondary Meeting Director node  becomes the active Meeting Director. Any conferences currently running  on the system are interrupted but attendants can dial back in  immediately.

-Dejan

New Member

CUMP 8.5; Should Director Fail-Over Cause Audio Conf Be Discon?

Thanks Dejan!

462
Views
0
Helpful
2
Replies