When scheduling from the MeetingPlace Express web page, the users that you can invite that pop-up are populated from the MeetingPlace Express user database. This is typically populated from the CUCM user database or Active Directory when the users logs into MeetingPlace Express. Make sure these users you want to invite have a MeetingPlace Express profile by going to the MeetingPlace Express web page, Administration, User Configuration, User Profile Management and searching for their username. You can also add users in here manually if you wish.
However if you are inviting users from the Outlook plug-in, when you start to enter a user's email address to invite them, this would be populated directly from Exchange.
If this does not answer your question, try posting an example of the data file you are seeing that is missing users.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...