07-08-2009 11:47 AM - edited 03-14-2019 04:19 AM
Hello Forum,
Is through ICM setup the only way to add a new PIM (CallManager)? Because I don't see how I can do it in Configuration Manager.
Thanks.
07-08-2009 12:22 PM
You will have to configure it in config manager, under the PG. Then install it using the ICM setup.
david
07-09-2009 09:30 AM
Thanks David,
I already have CallManager as a peripheral in Configuration manager. So I will just go to ICM setup and add another PIM I supposed. Because if I remember correctly from training is that ICM setup stops service. So I have to do this after hours.
Thanks
07-09-2009 09:45 AM
Correct, when you run the setup it will stop services.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: