Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Agent and Supervisor Desktop is in Partial service

Hi,

My CAD and CSD shows the status in the bottom as Partial service,when i analyse the service status by clicking on that " Agent Statistics Viewing is Inactive ". What i need to do to enable it.My environment is CME 7.0 , UCCX 7.0 with IP Communicator.

Thanks,

Hari

8 REPLIES
New Member

Re: Agent and Supervisor Desktop is in Partial service

Also iam using those agents in remote location connected through cisco vpn client.Any help ?

New Member

Agent and Supervisor Desktop is in Partial service

did you ever resolve this, i am having the same issue.

New Member

Hi:I was having the same

Hi:

I was having the same issue and I found that the issue was due to smart contact not miscommunicating to the voice platform.

I followed the resolution below and the issue got resolved. However in partial service portion I had all three inactive in CAD:

Call and Agent state log viewing

Agent Statistics viewing

Recording

 

Resolution:

Log into the UCCX administration page

- Restart the Cisco Desktop Enterprise Service

- Next you need to restart the Cisco Desktop recording and Statistics Service

- Finally, the Cisco Desktop Sync Service

New Member

Agent and Supervisor Desktop is in Partial service

Hi

Anyone can help with regards to this issue? because we also having the same issue.

New Member

Agent and Supervisor Desktop is in Partial service

Hi Everyone,

A few things too try.

First go too the app admin page, and then control center.  Please ensure you see Status: IN_SERVICE. 

If you do not,  please expand the servers tab and look for which service is having the issue and why.

If you see IN_SERVICE then openup agent desktop & login as an agent.  Once logged in and in a not ready state...  Click the words partial service.   A smaller window should come up and say which service is out of service.

Please let me know which service has the issue and your contact cetner version.

New Member

Agent and Supervisor Desktop is in Partial service

Hi rbblue234,

Thanks for the immediate response.  The service that showing partial is  " Agent Statistics Viewing". The version of our Contact center is UCCX 7.0 (2).

We check all of our servers are all in service. Please advise what should be the solution for this. Thanks in advance.

New Member

Agent and Supervisor Desktop is in Partial service

Hey Jasper,

Please do the following and attach the log for my review.

On the agent desktop, go to c:\program files\cisco\desktop\config

Open agent.cfg in notepad

Configure Threshold=OFF to Threshold=DEBUG

Close any version of agent desktop that's open on the computer, and relogin in. Once you are logged in and see partical service...  close the agent desktop program.

Please attach the log file for that time period to this post.  The log file is lcoated in

c:\Program Files\Cisco\Desktop\log

Please confirm you are able to login and pull historical reports for the last 24 hours as well.

Is this an HA setup for single server?

New Member

Agent and Supervisor Desktop is in Partial service

Hi Blue,

Luckly the partial service was already resolved. I don't know what happened and how does it happened, when we check it again the service was active..

I'll take note of the procedure that you gave to me, if the problem re-occurs i'll do your suggestion. thanks for the support.

2783
Views
0
Helpful
8
Replies
CreatePlease login to create content