cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
534
Views
0
Helpful
3
Replies

Agent goes to Not-Ready state immediately

oscar.perez
Level 1
Level 1

CCM 4.1(3) with CRS 4.0(4)

I have a single agent defined on a CSQ, the agent is in ready mode but as soon as a call goes into the queue the agent is set to Not-Ready mode, the call is keep on the queue and if the agent tries to go to Ready mode, it is set again to Not-Ready immediately. It may be related to CSS/Partitions between the CCM and the CRS system??

thanks in advanced.

Oscar Perez

3 Replies 3

Check the JTAPI logs, is the phone extension part of the jtapi/rmcm user?

david

Try creating a new agent and see if you get both agents logged in ready and what happens. Obviously chec the logs prior to get some pointer.

I found the root of this problem. It was related to CSS at the CUCM, some of the JTAPI-DNs didn't have the right CCS to reach out the agent DN. Please verify that all your JTAPI-DNs have the right CSS where the Agents can be reached.

Thanks everybody.

Oscar Perez

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: