Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Agent Phone is Ringing

When an Agent Phone is ringing (because of the select resource Step), what does the user must hear? Ring back? It is a way to control that?

4 REPLIES
New Member

Re: Agent Phone is Ringing

Yes, To resolve this issue,Set up a Send H225 User Info Message service parameter for Cisco CallManager service in CallManager. Perform the following steps:

In Cisco CallManager Administration, select Service > Service Parameter.

Select the correct server from the drop-down list.

Set the service to Cisco CallManager.

In the Send H225 User Info Message field, under the Cluster Wide Parameters (Device - H323) section, select H225 Info for Ring Back.

Reset the H.323 voice gateway.

After completing this procedure, the caller hears ring back when the agent phone is ringing.

New Member

Re: Agent Phone is Ringing

Using MGCP gateway. Already found the answer, Thanks

New Member

Re: Agent Phone is Ringing

How did you resole this for an mgcp gateway?

I have the same issue I would like to fix.

Thanks!

Gold

Re: Agent Phone is Ringing

Hi,

What the caller hears when the agent phone is ringing is the Network Music on Hold set up on the IPCC Express CTI Ports.

So, If you would like to change this behaviour you would change the NEtwork MoH of those CTI Ports or create a specific Device Pool for the CTI Ports where you will be able to change the Network MoH.

Hope this helps,

Juan Luis

171
Views
0
Helpful
4
Replies
CreatePlease to create content