I have some agents (including my own test agent) that are forced to a "not ready" state when a call comes in instead of the call being routed to them. I have tested multiple scripts all with the same result.
It has no problem if I start reactive debug in Script Editor. It happens to an IVR script. If I press an option within 4 seconds when prompt is playing, call will be treated as a direct call to the agent phone. CAD will change to Reserved and then quickly to Not Ready. When the call is completed, CAD will change to Ready immediately (Wrap-up time does not work). If I have only one level IVR, there is no problem. This only happens when there are two level IVRs (the same script for both of them). If I let the agent phone ring for 15 seconds (Call No Answer Timeout) then after 15 seconds, agent phone continue to ring, but CAD change to Reserved as it should be when receive an ACD call.
Fix: to switch from Layer 1 IVR to Layer 2 IVR, and from Layer 2 IVR to ACD, we use Call Redirect. We do not know what caused the problem. But when change the Call Redirect to Call Consulted Transfer, then the problem disappeared.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...