Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Agents going to "Not Ready"

Hello,

I have agents going to the not ready state after being idle for so may seconds in the ready state or after not answering a call from the ready state.

Any thoughts on why this is occuring?

Thanks in advance!

5 REPLIES

Re: Agents going to "Not Ready"

In the agent desk settings, it will show how long that agent can be idle before going not ready. If an agent misses a call it knocks them to not ready automagically. These are both expected behavior!

Thanks,

Chad

New Member

Re: Agents going to "Not Ready"

Chad,

Where exactly is this setting? Not sure if its in crs, supervisor dedsktop, cad or desktop admin?

Thanks again!

New Member

Re: Agents going to "Not Ready"

hbarrera2,

These settings are controlled under System --> System Parameters.

Thanks,

Robert

New Member

Re: Agents going to "Not Ready"

Nice! Thanks guys!!

New Member

Re: Agents going to "Not Ready"

We configured the wrap up time setting as 120 seconds in agent desk

settings tool. After the expiry of wrap up time, agent state is changing to not ready

state. But we want to change the state as ready(available) for the agent instead of not

ready.

Is there any settings for this to configure either in ICM or registry?

187
Views
0
Helpful
5
Replies