Let me be a little bit more specific. I am not attempting to create an applicaiton to connect to the AW, I am refering to Chapter 9 in the ICM Ent. 6.0 Configuration Guide.
For example, say I am trying to have my AW be the point of contact for a Cisco Collaboration Server and a Cisco E-Mail Server. Would I need a seperate CMS node for each application, or just one CMS node with multiple application instances setup?
good point about WIM and EIM, will need to check on it, I was considering CEM and CCS, since they had an issue with one being qualified with one Java build and the other one with another, hence requesting two different nodes.
I suspect this would not be the case for EIM+WIM, will check the docs.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...