In Large Deployment, as per SRND 9.X ,the number of Administration & Data Server roles is limited to 3 AW-HDS and 1 HDS-DDS or AW-HDS-DDS per Logger side.
Is it MAX 4 (3 AW-HDS & 1 HDS-DDS) can be deployed for one side of Logger? If we need more (3AW-HDS - 2 HDS-DDS) will it not be possible?
In AW-HDS ,i read that there will not be TCD or RCD(Call Detail) data ,then for reporting(custom/CUIC), is it must to connect always to HDS-DDS not AW-HDS ? In this case why does we need HDS under AW-HDS ? I am not able to see the significance.
If i keep on HDS-DDS on each logger lets say if the both HDS is down from each logger , this will impact reporting , how can we design in avoiding the situation.Can i have combination of 2 AW-HDS and 2-HDS-DDS on same logger?
I'm reading it the same way, you're limmited by the Logger, so you only can have 1 HDS-DDS. Now, look at your infrastructure, if your network has the possibility of having two seperate servers on two seperate networks go down, then your reporting is the least of the problems.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...