barge in and intercept not functioning in a CAD 7.5
I am presently working on a project which has UCCE setup with CAD 7.5 as agent desktop.We are running on 7.5(7) ICM and 7.5(8) CAD.I am facing a problem with Barge In and Intercept feature not functioning as expected.On a Barge In when the sup tries to barge on csd the caller is put on a hold and Agent desktop and Sup are connected.It needs to be completed from the phone and there is no direct conference established without the agent conferencing.With a Intercept again there is no direct transfer from the CAD to CSD and shows transfer cannot complete on the phone of the CAD.I am assuming there is no extra configuration for this and if my recording and Silent monitoring is working this should be quite simple.Am i missing anything here.The transfers and conferences at the telephony level are working fine.
I was facing the same issue on the base version and went with an upgrade but same problem.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...