UCCX 5.x. What do I need to do to allow agents to do blind transfers from CAD? Agents on top-level ACDs will be transferring large volumes of calls to other IVRs/ACDs and will need to ability. Thanks in advance,
I want to take an active incoming call that was answered by an agent using Cisco Agent Desktop and transfer it to another number in the directory ... but I only want the agent to have to press "transfer" once (hence a blind transfer as opposed to a supervised transfer when you press the button again after dialing).
Right now they have an active call, they highlight a directory entry, they press transfer, the button says something like "waiting", then they press transfer again and the call routes.
I want the agent to highlight a directory entry and press transfer once, and be done with the call.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...