We have ucce version 8 using cucm 8. A vendor setup our environment where 7111 agent extension can call any internal extension which is a different partition and not in the same css, however an internal cannot dial 7111. I checked for a route pattern in cucm that would block and internal extension from calling 7111. Also there are no traslation pattern in cucm and in icm. By the way we are using cvp. I ran dial number analyzer in cucm and it shows it block that pattern but i can find out where and what route pattern it is. Please help.
If an internal phone can not dial an agent extension, the internal phone probably doesn't have the agent extension's partition in its CSS. Maybe the existing CSSes weren't updated with the agent partition.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...