CAD Agent Desktop - Making 2nd call to Back office staff
Does anyone have a solution to the following question from a customer?
“Whilst an agent is talking to a caller, it would appear that the only option available to make a second call at the same time ie. in the case where a member of call centre staff wishes to talk to the back office team whilst the customer is on hold, the agent can put the caller on hold using CAD, however they would need to press the “New Call” button on the physical telephone to dial the 2nd number as the “Make Call” feature is not available within CAD (whist the call is on hold).
The agent will frequently make a 2nd call whilst on the phone to a customer. Not being able to use CAD to make this second call will cause a lot of confusion!Is there any way around this problem?”
I know that the ‘make call’ button is disabled when the agent is in a ready state, so how do they make a 2nd call if need? I suppose they could place the caller on hold and go not ready but I’m not sure if CAD allows this (I’m away from a test lab to check) and this would affect the agent stats.
Or perhaps they could initiate a supervised transfer discuss what they need to with the back office staff member then cancel the transfer and use the alternate button to switch between caller and back office staff?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...