Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CAD cannot start

Hi,

I am facing an issue with uccx 5 and cucm 6. In fact i could not start CAD. Every time i launch it i got the following error message : "License and ressource manager may be down" before even i can entre username and password.

I don't know what's the problem please advice.

3 REPLIES
New Member

Re: CAD cannot start

Have you tried restarting the service?

New Member

Re: CAD cannot start

Yes Actually I rebooted the server several times but it didn't help.

Re: CAD cannot start

This has been address on this forum before, please search around you will find the exact solution.

In short looks like your services are not running, in appadmin check your services under system, control center.

Also check your connectivity to the box that have your license info.

Please rate helpful posts,

Thanks,

Baseer.

141
Views
0
Helpful
3
Replies