Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

CAD dosnt go to not-ready when did not answer a call

hi guys

i have strange ssue the CAD if did not answer the call it should automticly go to not ready and the call taken to the qeue agin

but what happenening is the call lets say setup in te selct resource to 15 seconds the time

the call ring 15 sec after that it taken off that cad and directly ring the same CAD again and the status show reserved !!!

any idea

in CM i made the busy out and maximum call wait to 1 each but no luck !!!

thank you

  • Contact Center
127
Views
0
Helpful
0
Replies
This widget could not be displayed.