Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CAD - Enable Reason Code only for by agent group

Hi,

Customer runs CAD 7.0(2) (Premium Version), Build 7.0.2.4

I saw in this forum that using CAD cal flow group you can retrict reason code to agent group and not using them for all contact center.

But once reason code enable in CAD you always have to specify reason when close toolbar for example.

Customer does not want any reason code prompt for some agent and enable it for other ones.

Is there any way to configure that reason only for only a part of contact center agents in CAD 7.0(2) (Premium Version), Build 7.0.2.4????

Thank you.

2 REPLIES

Re: CAD - Enable Reason Code only for by agent group

I don't think v7.0x had that feature. It was introduced in v7.1.

New Member

Re: CAD - Enable Reason Code only for by agent group

hi,

afaik, in 7.01 you can define a new group with desktop admin and choose the codes you want to use for that group (moving from available to selected and vice-versa). Then you can assign the agents to use that group, with that specs.

Regards,

Met.

279
Views
0
Helpful
2
Replies