Is there a way to blank out the CAD Login screen each time you start CAD? I know you can do it by modifying the agent.ini properties but I was looking/hoping for a server side change. Essentially I want the agents to have to enter their username/password each time they start CAD and not have the last agent's username populated. CAD 7.2
I don't believe that there are any settings within CAD that will block the saving of the username and extension. But as you said, the login information is stored in the agent.ini or phonedev.ini, depending on the version. You could create an Agent Management Workflow which launches a BAT file to replace this agent.ini/phonedev.ini file on agent logout.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...