Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CAD Not Ready State

                   I have an agent, when in the ready state and they get a call on their private line and don't answer it, it puts them in the not ready state with the reason code (ring no answer). The agent has to put themselves back into the ready state. Please Advise. Thank You.

1 ACCEPTED SOLUTION

Accepted Solutions

CAD Not Ready State

Hi Robert,

If the above query is related to UCCX, CAD component.

Please access the UCCX System parameters page, and change the state of RONA to Ready state, by default it is set to Not Ready state.

Please note that this aaplies to all the Agents in the UCCX, if someone doesn't answer the call it will again put it back to Ready state.

Hope it helps.

Anand

pls rate helpful posts !!

1 REPLY

CAD Not Ready State

Hi Robert,

If the above query is related to UCCX, CAD component.

Please access the UCCX System parameters page, and change the state of RONA to Ready state, by default it is set to Not Ready state.

Please note that this aaplies to all the Agents in the UCCX, if someone doesn't answer the call it will again put it back to Ready state.

Hope it helps.

Anand

pls rate helpful posts !!

570
Views
0
Helpful
1
Replies