CAD outbound call stays active after conversation is finished and droped
I am using the IPCCE 7.1(5) with CCM 5.1(3) and CAD 7.1(2).
I have the following problem related to CAD:
When I make the outbound call (it is the same with outbound campaign calls) to outside the company number, after i finish the conversation i can not close (end) the call. If the other side ends the call, IP Communicator drop the call normaly, but in CAD the call stays on the screen, although the CAD goes to ready/not ready state as it must be.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.