Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

CAD UCCE Reason Codes Question

In UCCE CAD 7.5.4 and later Spanlink came out with a new feature where a agent can change thier "Not Ready" reason code without going "Ready"->"NotReady".  I have a customer who is running 7.5.6 and does not like this feature and would like to turn it off. There is nothing in Cisco Administration Desktop application that controls this (i.e. enable / disable of this feature) Does any one know if there is a Registry or configuration file that can turn off this feature? - Thank for your help! - Jim

1 REPLY
Bronze

Re: CAD UCCE Reason Codes Question

Not as far as I know. Haven't asked TAC or anything yet though. It's annoying because when going Not Ready > Not Ready it doesn't write an entry into the Agent_State_Trace table, only the Agent_Event_Detail which one of my clients needed to use for reporting..

431
Views
0
Helpful
1
Replies
CreatePlease to create content